Jaw pain after new crowns

This year I had extensive dental work done: crowns and bridges on all my teeth. I thought after I spent so much money, my teeth would be perfect. They’re not. In fact, the situation is barely tolerable. I have constant jaw pain and headaches. Financially, I can’t afford to have all this work redone. Even though I have insurance, it only covered a bit of the cost.

Before any dental work was done, my natural teeth were worn down. Some were little more than stubs. My teeth were weak and chipped easily, and the enamel was discolored too.  On the bottom right of my mouth, #29 was missing, and #10 and #11 were missing on the top left. As you can imagine, I avoided letting people see my teeth.

There was also an annoying, uncomfortable clicking on the right side of my jaw, near my ear, whenever I chewed or talked. It started after I was injured in a bike accident and never fully healed. Since I had the crowns and bridges put in, it has been even worse.

I went to a cosmetic dentist planning to have just my front teeth fixed. At my consultation, the dentist said he would need to fix all my teeth. He couldn’t do just the front teeth. He said my bite was too tight, and he needed to open it before doing the front.

He did the bottom teeth first, and it went fine. But last month I came back for the top teeth, and they don’t fit right. When I close my mouth, my teeth touch on the right side, but they don’t touch on the left–there’s a gap.  The bridge that is over teeth 10 and 11 clashes hard against my bottom teeth every time I chew and talk, so by the end of the day I have a terrible headache and my jaw is throbbing.

I will say that the teeth look beautiful, and I’d be happy with them if it weren’t for the pain in my jaw and how they fit in my mouth. The crowns and bridges are all permanently cemented. Do you think it’s possible for the dentist to fix this by grinding down the bridge so it doesn’t impact my lower jaw so much every time I bite? Or will it have to be removed and replaced?

Tammy in New Orleans

Dear Tammy,

The dentistry term for the work you had done is full-mouth reconstruction. And the experience you’re having is pretty much the worst-case scenario for that process. I’m sorry you’re going through this. Though it is fixable, at least some of the work will have to be redone. As you already are seeing, there’s a painful impact on your jaw.

The clicking you’ve described sounds like TMJ pain, and I’m not surprised that having poorly fitted bridges and crowns is making it worse. A full-mouth reconstruction goes far beyond the skills taught in basic dental school. You should see a TMJ specialist who is trained in full-mouth reconstruction. Some of the institutions that provide this advanced training include the Las Vegas Institute for Advanced Dental Studies, The Pankey Institute, and the Dawson Center for Advanced Dental Study.

Even for a dentist with advanced training, a full-mouth reconstruction is a complex procedure that requires time, careful planning, and ongoing patient feedback. In your situation, where you have an over-closed bite, special care should be taken to open the bite slowly.

Typically, an over-closed bite is opened gently with temporary crowns, which are then adjusted until the desired vertical dimension is reached. Only then can permanent porcelain crowns and bridges be placed. Before any permanent fixtures are cemented in, there should be a full-mouth try-in of all the crowns and bridges. That would have prevented the problem you’ve encountered here, with a bridge that doesn’t fit in your mouth.

Perhaps the bridge needs such a small adjustment that you could have your dentist do it and be fine. But you’ve said that the teeth don’t even touch on the other side, so it sounds like the dentist might have to grind deep, perhaps through the porcelain on the bridge. The plan was for this work to open your bite, but grinding the bridge down could diminish your vertical dimension again. Ideally, a change like that would happen while the bridge is in the laboratory. Grinding it down when it’s already in your mouth is harder to do precisely. Also, a ground-down surface is not as good for your oral health and nutrition as having teeth crafted so the indents and cusps complement each other.

Is it possible that your dentist did trial a temporary bridge that fit, but then the permanent bridge didn’t fully seat? That can happen, but the bridge would still need to be redone.

I encourage you to get a second opinion before having this dentist try to fix his work, especially given your TMJ. Dr. Delaune is a Dawson-trained dentist and would be happy to see you in our Metairie office to discuss your options.

This blog brought to you by Delaune Dental, a full-mouth reconstruction dentist in Metairie, LA.